BBQ repair good Changhong LCD TV LT26610 screen
A new rule from the Drug Enforcement Administration (DEA) threatens to upend the American hemp industry, and could even result in criminal prosecutions for manufacturers of CBD and delta-8 THC products.
The DEA says the [interim final rule," issued Aug. 20, is simply a matter of adjusting its own regulations to account for changes to the Controlled Substances Act that were mandated by the 2018 Farm Bill (or Agricultural Improvement Act) that legalized hemp and CBD production. The new rule [merely conforms DEA`s regulations to the statutory amendments to the CSA that have already taken effect," says the agency. The new rule doesn`t break any ground, according to the DEA.
But many experts on cannabis and hemp law say the DEA rule creates a potential pathway the law enforcement agency could use to prosecute hemp processors and producers of CBD (cannabidiol) and delta-8 THC (or Δ8THC) products. There are two issues: partially processed CBD, and [synthetically derived" delta-8 THC.
Cbd Pod System Oem,Cbd Vape Pod Oem,Best Cbd Pod System,Cbd Pod System Shenzhen MASON VAP Technology Co., Ltd. , https://www.e-cigarettefactory.com
The TV was sent by a hotel we cooperated with. The last batch of master identification screens were always placed in the small black room. It was found that the switch can have sound, the screen backlight is bright gray screen with horizontal bar line, and the screen is integrated with logic board. There is no output after the 25V input side IC on the VGH filter. The VGH online resistance is unstable after the IC is measured. After disconnecting the VGH to the screen current limiting resistor, the IC output voltage has a 22V up and down change, indicating that the edge board is no problem. It seems that this resistance comes from inside the screen or from the ear.
In recent years, I have been more popular in barbecues. I have already eaten a few screens inside the open circuit [jumper solution]. I haven't seen the internal short circuit. It doesn't matter if the small machine burns out and then presses the screen or scraps it. Give the screen a 12v no response....15v....17v When I added 20v, I still didn't look at the ammeter. I felt that the sparks on the screen ear flashed a bit, and it was a pity that I didn’t fly the monster. Going, measuring VGH to the ground resistance does return to normal hundreds of K, quiet down to analyze the line, the original line VGH is squatting, drop a drop of insulating paint and then smash, conclusion cable leakage.