4). Perfect for rearview mirror, grille and rear deck applications
6). Waterproof and shakeproof
4). Perfect for rearview mirror, grille and rear deck applications
6). Waterproof and shakeproof
Model NO.: LED265
Flashing Patterns: 18
Trademark: XingYuan
Transport Package: Exporting Carton
Origin: China
HS Code: 8512209000
Model NO.: LED265
Flashing Patterns: 18
Trademark: XingYuan
Transport Package: Exporting Carton
Origin: China
HS Code: 8512209000
1. Features
1). G-3 LEDs with 8 bulbs
2). 18 flash patters to pick up and can flash two lightheads together for synchronization .
3). Weather-proof housingÂ
5). Perfect for police fire EMS and construction vehicle lighting and airforceÂ
2. Specifiation
Work voltage
DC12V/DC24V
Consume electric current:
<=1.2A
Environment
-40 ºC~ +50 ºC
Warning light color
Red / Blue / Amber / Clear / Green
Power supply way
Constant voltage current control
Lens material
PC
Flash patterns
18
A. Position the unit in its proposed mounting location. Draw a pencil line onto the mounting surface along the top and bottom of the extrusion and a "centerline" centered between the two.
B. Two 1/4" holes are required to mount this unit. These holes may be located anywhere along the holes as far apart as possible. Mark the hole location onto the mounting surface.
C. Using a 1/4" drill bit, drill a hole in each of the areas scribed in the previous step.
D. Slide the 2 carriage bolts (installed in the rear of the bar) insert them into the mounting holes.
E. Secure the unit by threading the flat washer and elastic stop nut onto each bolt and tightening them firmly.
4. Wiring
See illustration below for wiring information
WARNING! All customer-supplied wires that connect to the positive terminal of the battery must be sized to supply at least 125% of the maximum operating current and at the battery to carry the load. DO NOT USE CIRCUIT BREAKER SWITH THIS PRODUCT!
1. Features
1). G-3 LEDs with 8 bulbs
2). 18 flash patters to pick up and can flash two lightheads together for synchronization .
3). Weather-proof housingÂ
5). Perfect for police fire EMS and construction vehicle lighting and airforceÂ
2. Specifiation
Work voltage
DC12V/DC24V
Consume electric current:
<=1.2A
Environment
-40 ºC~ +50 ºC
Warning light color
Red / Blue / Amber / Clear / Green
Power supply way
Constant voltage current control
Lens material
PC
Flash patterns
18
A. Position the unit in its proposed mounting location. Draw a pencil line onto the mounting surface along the top and bottom of the extrusion and a "centerline" centered between the two.
B. Two 1/4" holes are required to mount this unit. These holes may be located anywhere along the holes as far apart as possible. Mark the hole location onto the mounting surface.
C. Using a 1/4" drill bit, drill a hole in each of the areas scribed in the previous step.
D. Slide the 2 carriage bolts (installed in the rear of the bar) insert them into the mounting holes.
E. Secure the unit by threading the flat washer and elastic stop nut onto each bolt and tightening them firmly.
4. Wiring
See illustration below for wiring information
WARNING! All customer-supplied wires that connect to the positive terminal of the battery must be sized to supply at least 125% of the maximum operating current and at the battery to carry the load. DO NOT USE CIRCUIT BREAKER SWITH THIS PRODUCT!